HVAC & Plumbing Services in Blandon, PA

Heat inspection on a Trane Furnace.

Installed a Daikin Furnace and A/C.

Furnace inspection

After hours call for no heat on a Rheem gas furnace. Spark ignitor gap was incorrect, reset electrode and system fired up normally.

Tune up on rehm furnace.

Heating tuneup on a miller furnace.

Cpp heat tune up.

I repaired a Goodman GSX14 air conditioner that was not cooling properly. After diagnosing low refrigerant levels, I located a small leak in the evaporator coil. I repaired the leak using a refrigerant sealant and refilled the system with R-410A refrigerant. After testing the unit, it returned to full cooling capacity, and the leak was no longer an issue.

I repaired a broken sewer line using a trenchless pipe-lining method. After identifying the damaged section with a camera inspection, I inserted a liner coated with epoxy into the 4” sewer pipe. The liner was cured in place, creating a seamless inner pipe. This restored proper drainage and eliminated the need for extensive excavation.

I performed maintenance on a Mitsubishi MSZ-GL ductless mini-split system. I started by cleaning the indoor air handler's filters and coils to ensure proper airflow. I inspected the outdoor condenser unit for any debris and cleaned the fins to improve efficiency. I also checked the refrigerant levels and tested the electrical connections. After running the system, I confirmed it was providing optimal heating and cooling, with all components operating smoothly.

Arrived at a residential home to tune up a Lennox heat pump for AC mode. The heat pump is operating properly for the home and the customer was pleased with the maintenance.

Received a call about a leaking hose bib at a residential property. Upon arrival, I isolated the water supply by turning off the nearest angle stop. I then used a basin wrench to remove the faulty hose bib, taking care to avoid damaging the copper supply line. After cleaning the threaded fitting, I applied fresh teflon tape and installed a new lead-free 1/2" hose bib with an integrated vacuum breaker for backflow prevention. Once the new hose bib was hand-tightened, I slowly opened the angle stop to check for leaks under pressure. Finding no drips, I completed the installation by securing the hose bib with a bib hammer. Following a final leak test, I restored full water service to the outside faucet. The new hose bib meets current plumbing codes and will provide years of durable, leak-free operation.

Fixed a well pump water system in Blandon, PA, ensuring the in-floor radiant heating systems operated effectively. Initial steps included evaluating the well pump for leaks or operational issues, ensuring sufficient water circulation. I also assessed and adjusted the boiler, piping, and controls of the radiant heating setup for optimal efficiency. All systems are now performing excellently.

Today, I completed a comprehensive repiping of a residential home using cross-linked polyethylene (PEX) piping. The project involved removing outdated galvanized pipes, strategically installing PEX for improved water flow and reduced corrosion risk, and connecting fixtures with secure, leak-proof fittings for long-term reliability.

Just completed the installation of a Navien NPE-240A tankless water heater for a Blandon, PA family with high hot water demands. The process was straightforward, and now they have endless hot water without the hassle of a tank.

Just installed a UV air purifier for a customer in Blandon, PA. Their child with asthma will benefit from improved indoor air quality. UV purifiers effectively kill airborne pathogens, reducing asthma triggers in the home.

In Blandon, PA, I installed a new heat pump, replacing an outdated unit with declining efficiency. The new heat pump, a Carrier Infinity Series model, was installed along with necessary ductwork modifications and testing. The installation process took approximately two days, ensuring efficient heating and cooling for the homeowner in Blandon.

In Blandon, PA, I replaced an outdated furnace, a 20-year-old unit with declining efficiency, with a Trane XV95 model. The installation completed in a day. The new furnace ensures improved heating efficiency and reliability for the homeowner in Blandon, PA.

Water quality testing service call. Performed water quality test to determine the contaminants in the customer's water. Provided estimate for water heater installation at a later date. Also provided information about Laundry Pro.

UV light filtration installation. Installed new UV light air purifier unit into customer's existing HVAC system. Took them through proper operation and explained how it will improve indoor air quality.

Furnace maintenance service call. Went through full heating tune-up on 6-year-old Amana system. Everything checks out.

AC maintenance service call. Customer has a 2-year-old Carrier system. Checked system top top bottom, went through full air conditioning maintenance checklist. System is working great. Signed customer up for Customer Partner Plan for regular maintenance.